NEW! ACU Approved toe guards for swingarms. These are required to pass ACU scrutineering when racing and protect hands and feet from being mangled through the rear wheel sprocket! Easily fitted to most swingarms with variable mounting points from 30-65mm between centres.

Available in plain aluminium or painted black

Our Ducati race sump plugs are made from billet aluminium and then hard anodised to provide improved wear resistance. No longer will you struggle to remove the sump plug as we have done away with the recessed allen socket and incorporated an external hex-head to allow the use of a socket. Each face has been pre-drilled too, to make lock-wiring your sump plug as easy as possible. These will also fit the oil filler cap, as it uses the same sized thread! A must for the Ducati racer. Note: Not for use on Deep Sump engines - a version for these will follow!

Our Ducati race sump plugs are made from billet 7075-T7 aluminum alloy and then anodised to provide improved wear resistance. No longer will you struggle to remove the sump plug as we have done away with the recessed allen socket and incorporated an external hex-head to allow the use of a socket. Each face has been pre-drilled to make lock-wiring your sump plug as easy as possible. A must for the Ducati racer.

Note: Only for use on Deep Sump engines - 1198, 1098, 848, D16RR, 999, 749, MultiStrada 1200, Diavel. Please check to confirm this is the correct sump plug for your engine!

All you need to bling up your clutch! This clutch kit comprises of 6x Stainless Clutch Springs, 6x Aluminium Anodised Clutch Spring Caps and 6x Stainless Spring Bolts. Replace those nasty (and rusting!) clutch springs to give your clutch the look it deserves! Available with Black, Red or Gold spring caps.

Suitable for all Ducati dry clutches, including: 748, 916, 996, 998, 749, 999, Monster, ST, SuperSport, Hypermotard, etc! Note that these are NOT suitable for 1098, 1198 and Streetfighter clutches unless you re-use your original clutch spring caps.

Genuine SKF Bearing. Fully sealed clutch pressure plate bearing, type 6201 2RS GL. Dimensions 12 inner x 32 outer  x 10 thickness in mm.

Standard fit for OEM and most aftermarket clutch pressure plates.

Rubber well nuts (also known as Rawl Nuts) make an appearance all over your Ducati, used where vibration is a problem to stop bolts undoing themselves. Over time they will harden, crack and sometimes even fall to pieces. We sell them in packs of 8 well nuts for a fiver - Ducati sell them at £6 each! This is for a pack of 8 rubber well nuts to accept M5 bolts, the well nut is 15mm in length.

Rubber well nuts (also known as Rawl Nuts) make an appearance all over your Ducati, used where vibration is a problem to stop bolts undoing themselves. Over time they will harden, crack and sometimes even fall to pieces. We sell them in packs of 8 well nuts for a fiver - Ducati sell them at £6 each! This is for a pack of 8 rubber well nuts to accept M6 bolts, the well nut is 15mm in length.